Alpine Ski Bikes

091 Front Through-Axle Bracket 110 x 15mm "Boost"

  • $ 99.99
  • Save $ 100.00

This bracket will work with any 100mm x 15mm or 110mm x 15mm through-axle design including the Maxle. This is a 100mm bracket that also includes two 5mm spacers to put on either side of the axle to make it fit a 110mm x 15mm "Boost" fork.   

It features a silicone-lubricated, sealed axle bushing system that utilizes rubber O-rings to keep the lube in and water out. Be sure the O-rings are properly seated in their grooves before tightening the axle into place.  This bracket is 3" wide with an axle height of 6.4".

There are 5 holes on the stabilizer arm which allows the bungee to be positioned at the top for more rigid resistance or near the bottom to allow a smoother terrain-hugging ski motion. The stabilizer arm can be rotated to any angle to set the proper ski attitude (slightly tip-high).

The bungees are made of natural rubber which has much better cold weather performance than the common EPDM straps. If you want to replace worn out straps or add more straps to increase resistance, you can buy 10 natural rubber 15-inch bungees for $8.99 at The mounting holes will fit skis with mounting patterns of 40x40mm (which most skiboards use) or 100x50mm (which all Lenzsport skis use). 

*Note:  don't forget to order a rear bracket, foot pegs, and skis.