Alpine Ski Bikes

06 Ski-MX Conversion kit for 26" XC Mountain Bikes

  • $ 479.97


This kit is for 26" mountain bikes with 100x9mm threaded front axles and 135x9mm rear axles.  Most cross-country mountain bikes have these axle sizes.  If you have threaded quick release axles, then this is the right kit.  If you have non-threaded through-axles, then you will need to pick each bracket separately from the products page. 

These brackets feature a silicone-lubricated, sealed axle bushing system that utilizes rubber O-rings to keep the lube in and water out. Be sure the O-rings are properly seated in their grooves before tightening the axle into place.

There are 5 holes on the stabilizer arm which allows the bungee to be positioned at the top for more rigid resistance or near the bottom to allow a smoother terrain-hugging ski motion.  The stabilizer arm can be rotated to any angle to set the proper ski attitude (level or slightly tip-high).

The bungees are made of natural rubber which has much better cold weather performance than the common EPDM straps. If you want to replace worn out straps or add more straps to increase resistance, you can buy 10 natural rubber 15-inch bungees for $8.99 at uscargocontrol.com. The mounting holes will fit 40x40mm (which most skiboards use) or 100x50mm (which all Lenzsport skis use) mounting patterns.  These brackets are 3" wide with an axle height of 6.4".

This kit comes with extruded aluminum foot pegs for super sure grip on any type of boot in any type of snow condition.